11) Tapping input shaft end with plastic hammer, push it out as as-
sembly from case a little, then take out input shaft assembly (1),
counter shaft assembly (2), high speed gear shift shaft (3) and
low speed gear shift shaft (4) all at once.
12) Remove counter shaft left bearing cup from left case.
13) Remove differential side left oil seal also from left case.
RIGHT CASE
1) Remove differential gear assembly (1) from right case (2).
2) Remove bolt and then pull out VSS (3).
3) If input shaft right bearing has been left in right case, pull it out
by using special tools.
Remove input shaft oil seal (1) by using special tools.
Special Tool
(A): 09930-30102
(B): 09923-74510
4) Also pull out countershaft right bearing cup (2) by using special
tools (bearing remover 09941-64511 with sliding shaft
09930-30102).
MANUAL TRANSMISSION 7A-19