Suzuki WagonR+ RB310 Service Manual page 2786

SELECTOR CABLE
1. Selector lever ass'y
2. Selector cable
3. Selector housing
4. Cable bracket
5. Shift control lever
6. Clip
REMOVAL
1) Remove parking brake lever cover.
2) Remove console box.
3) Disconnect selector cable from selector lever and then detach
from bracket.
4) Remove clip and disconnect selector cable from transmission.
5) Remove selector housing from dash panel.
INSTALLATION
Install selector cable by reversing removal procedure.
The important steps in installation are as follows.
D Apply grease to pin and cable joint.
D Tighten bolts and nut in upper figure to specified torque.
D Adjusting procedure is as follows.
AUTOMATIC TRANSMISSION (4 A / T) 7B-55
7. Selector housing bolt
8. Shift control lever pin:
Apply lithium grease
99000-25010 to all around pin
9. Selector lever pin:
Apply lithium grease
99000-25010 to all around pin