Suzuki WagonR+ RB310 Service Manual page 2262

[A]
[B]
[A]: Without ABS
[B]: With ABS
1. 4-way joint
2. Master cylinder
3. LSPV
4. Right brake caliper
5. Left brake caliper
6. Right wheel cylinder
7. Left wheel cylinder
8. ABS hydraulic unit
: Air bleeding point
CHECK AND ADJUSTMENT
BLEEDING BRAKES
CAUTION:
Brake fluid is extremely damaging to paint. If fluid should
accidentally touch painted surface, immediately wipe fluid
from paint and clean painted surface.
NOTE:
For vehicle equipped with ABS, make sure that ignition switch
turns off.
Hydraulic lines of brake system are based on the diagonal split sys-
tem. When a brake pipe or hose was disconnected at the wheel,
bleeding operation must be performed at both ends of the line of the
removed pipe or hose. When any joint part of the master cylinder
or other joint part between the master cylinder and each brake
(wheel) was removed, the hydraulic brake system must be bled at
all 4 wheel brakes.
NOTE:
Perform bleeding operation starting with wheel cylinder far-
thest from master cylinder and then at front caliper of the same
brake line. Do the same on the other brake line.
1) Fill master cylinder reservoir with brake fluid and keep at least
one-half full of fluid during bleeding operation.
2) Remove bleeder plug cap (1).
Attach a vinyl tube (2) to bleeder plug of wheel cylinder, and in-
sert the other end into container (3).
3) Depress brake pedal several times, and then while holding it de-
pressed, loosen bleeder plug about one-third to one half turn.
BRAKES 5-7