Suzuki WagonR+ RB310 Service Manual page 2515

6A1-40 ENGINE MECHANICAL
VALVES AND CYLINDER HEAD
1. Valve cotters:
Apply engine oil.
2. Valve spring retainer:
Apply engine oil.
3. Valve spring:
Apply engine oil.
Be sure to position
spring in place with its
bottom end (small-pitch
end) facing the bottom
(valve spring seat side).
4. Valve stem seal:
Apply engine oil.
FWD
5. Valve spring seat:
Apply engine oil.
6. Exhaust valve:
Apply engine oil to valve stem.
7. Intake valve:
Apply engine oil to valve stem.
8. Cylinder head bolt:
Apply engine oil.
9. Camshaft housing bolt:
Apply engine oil.
REMOVAL
1) Relieve fuel pressure according to procedure described in Sec-
tion 6.
2) Disconnect negative cable at battery.
3) Drain cooling system.
4) Remove air cleaner outlet hose No.1 and No.2 with intake joint
and suction pipe as previously outlined.
10. Camshaft housing:
Apply engine oil to sliding surface of
each housing against camshaft journal.
Apply sealant to mating surface of
No.6 housing.
11. Valve guide:
Apply engine oil to valve guide bore.
12. Oil venturi plug
13. Cylinder head gasket:
"TOP" mark provided on gasket comes to
crankshaft pulley side, facing up
(toward cylinder head side).
14. Dowel pin