Suzuki WagonR+ RB310 Service Manual page 2923

8D-12 WINDOWS, MIRRORS, SECURITY AND LOCKS
REAR WIPER AND WASHER SWITCH
REMOVAL
1) Disconnect negative cable at battery.
2) Remove steering column cover. Refer to step 5) of CONTACT
COIL CABLE ASSEMBLY REMOVAL in Section 3C.
3) Pull out wiper and washer switch assembly.
4) Disconnect wiper and washer switch lead wire coupler.
INSPECTION
REAR WASHER ON
Check the continuity at each switch position. If any continuity is not
REAR WIPER ON obtained, replace switch.
Position
RR WASHER
INSTALLATION
1) Connect wiper and washer switch lead wire coupler.
2) Push wiper and washer switch assembly into steering column till
it clicks.
3) Install steering column cover. Reverse removal procedure.
REAR WIPER MOTOR
INSPECTION
1) TESTING WIPER MOTOR
As shown left, use a 12 V battery to connect its (+) terminal to
terminal "B", and its (–) terminal to black lead wire (2). Then mo-
tor (1) should rotate at 35 to 45 rpm.
Terminal
a
OFF
ON
i f g h