Suzuki WagonR+ RB310 Service Manual page 2642

1. Front housing
2. Front armature shaft bush:
Apply lithium grease
99000-25010 to inside
and outside.
3. Snap ring
4. Pinion stop ring:
Note the installing
direction, and the detail
refer to page 6G-13.
5. Pinion gear
6. Over-running clutch:
Apply lithium grease
99000-25010 to joint of
magnetic switch and
over-running clutch.
7. Lever:
Apply lithium grease
99000-25010 to joint of
magnetic switch and
over-running.
Note the installing direction.
8. Plate
9. Seal rubber
UNIT REPAIR OVERHAUL
10. Plunger:
Apply lithium grease
99000-25010 to plunger.
11. Magnetic switch
12. Internal gear:
Apply lithium grease
99000-25010 to spline.
13. Planetary carrier shaft:
Apply lithium grease
99000-25010 to spline.
14. Planetary gear:
Apply lithium grease
99000-25010 to spline.
15. Packing
16. Ball:
Apply lithium grease
99000-25010.
17. York
For overhauling of starting motor, it is recommended that compo-
nent parts should be cleaned thoroughly. However, yoke, armature
coil, over-running clutch, magnetic switch assembly, rubber or plas-
tic parts are NOT ALLOWED to be washed in degreasing tank or
with grease dissolving solvent. Those parts should be cleaned by
blowing air and wiping with cloth.
DISMOUNTING AND REMOUNTING
1) Disconnect positive (+) and negative (–) battery lead cables at
battery.
2) Remove battery and battery tray.
3) Disconnect EVAP canister (1) and remove cable clamp (2).
13.3 N
18. Armature:
Apply grease
99000-25010 to spline.
19. Brush holder
20. Brush spring
21. Brush
22. Rear bracket bush:
Apply lithium grease
99000-25010 to inside
and outside.
23. Rear bracket
24. Bolt
25. Nut
CRANKING SYSTEM 6G-5
.
m (1.33 kg-m)
.
6.0 N m
(0.6 kg-m)
:Tightening Torque
: Do not reuse