Suzuki WagonR+ RB310 Service Manual page 2697

7A-6 MANUAL TRANSMISSION
DIFFERENTIAL SIDE OIL SEAL
REPLACEMENT
1) Lift up vehicle and drain transmission oil.
2) Remove wheel, and then remove tie-rod end nut.
3) Disconnect tie-rod end from knuckle by using puller (1).
4) Remove two stabilizer mount brackets from vehicle body.
5) Remove ball stud bolt and then separate suspension arm from
knuckle.
6) By using large size screwdrivers (2), pull out drive shaft joint (1)
so as to release snap ring fitting of joint spline at differential side.
Pushing knuckle portion outward, detach drive shaft at differen-
tial side.
7) Remove oil seal (1) and install a new one until it becomes flush
with case surface by using special tool and hammer.
NOTE:
When installing oil seal, face its spring side inward.
Special Tool
(A): 09913-75510
8) Apply grease to oil seal lip and at the same time check drive shaft
where oil seal contacts and make sure of its smoothness.
"A": Grease A 99000-25010
9) Insert drive shaft joint to differential gear.
CAUTION:
D Be careful not to scratch oil seal lip with drive shaft joint
while inserting.
D Make sure to insert drive shaft joint fully and seat its
snap ring as it was.
D Do not hit joint boot with hammer or the like. Nothing
but hands is allowed to use when inserting joint.