Suzuki WagonR+ RB310 Service Manual page 2500

"A"
CLEANING
D Clean mating surface of oil pan and cylinder block.
Remove oil, old sealant, and dusts from mating surfaces and oil
pan inside.
D Clean oil pump strainer screen.
INSTALLATION
1) Apply sealant to oil pan mating surface continuously as shown
in figure.
"A" Sealant: 99000-31150
2) Install oil pump strainer (1) and oil pan (3) as described below.
Install O-ring (2) into cylinder block securely as shown in figure.
Install oil pump strainer to cylinder block.
Tighten strainer bolt first and then bracket bolt to specified
torque.
Tightening Torque
.
(a): 11 N m (1.1 kg-m, 8.0 lb-ft)
After fitting oil pan to cylinder block, run in securing bolts and
start tightening at the center: move wrench outward, tightening
one bolt at a time.
Tighten bolts to specified torque.
Tightening Torque
.
(b): 11 N m (1.1 kg-m, 8.0 lb-ft)
3) Install gasket and drain plug to oil pan.
Tighten drain plug to specified torque.
Tightening Torque
.
(a): 50 N m (5.0 kg-m, 36.5 lb-ft)
ENGINE MECHANICAL 6A1-25