6) Remove exhaust manifold (1) and its gasket from cylinder head.
7) Remove catalytic converter case gasket and exhaust No.1 pipe
seal ring (rear side).
INSTALLATION
1) Install new gaskets to cylinder head, catalytic converter case
and exhaust No.1 pipe (rear side).
2) Install exhaust manifold.
Tighten manifold bolts and nuts to specified torque.
Tightening Torque
(a): 23 N
3) Install exhaust manifold cover.
4) Connect oxygen sensor No.1 coupler (1) and clamp (2) its wire
securely.
5) Install catalytic converter case (3) with exhaust No.1 pipe (2) to
(a)
exhaust manifold.
Tightening Torque
(a): 42 N
6) Connect oxygen sensor No.2 (1) coupler, refer to EXHAUST
SYSTEM section.
7) Connect negative cable at battery.
8) Check exhaust system for exhaust gas leakage.
.
m (2.3 kg-m, 17.0 lb-ft)
.
m (4.2 kg-m, 30.5 lb-ft)
ENGINE MECHANICAL 6A1-17