Suzuki WagonR+ RB310 Service Manual page 2534

No.1 Cylinder
No.2 Cylinder
No.3 Cylinder
No.4 Cylinder
Crank
pulley
side
5) Remove cap and using a scale (2) on plasticgauge envelope,
measure gaging plastic (1) width at the widest point (clear-
ance).
If clearance exceeds its limit, use a new standard size bearing
and remeasure clearance.
Bearing
clearance
6) If clearance can not be brought to within its limit even by using
a new standard size bearing, regrind crankpin to undersize
and use 0.25 mm undersize bearing.
ASSEMBLY
NOTE:
Two sizes of piston are available as standard size spare part
so as to ensure proper piston-to-cylinder clearance. When
installing a standard size piston, make sure to match piston
with cylinder as follows.
a) Each piston has stamped number 1 or 2 as shown. It represents
1 or 2
outer diameter of piston.
b) There are also stamped numbers of 1 and 2 on the cylinder block
Piston
as shown. The first number represents inner diameter of No.1
cylinder, the second number of No.2 cylinder, the third number
of No.3 cylinder and the fourth number of No.4 cylinder.
Flywheel
side
Item Standard
0.020 – 0.050 mm
(0.0008 – 0.0019 in.)
ENGINE MECHANICAL 6A1-59
Limit
0.080 mm
(0.0031 in.)