5B-8 FRONT BRAKE
2) Remove piston boot (1) prying it with a metal tool (2) (no sharp
edge).
CAUTION:
Be careful not to damage inside (bore side) of cylinder.
3) Remove piston seal using a thin blade like a thickness gauge,
etc.
CAUTION:
Be careful not to damage inside (bore side) of cylinder.
INSPECTION
Piston Boot
Check boot for breakage, crack and damage. If defective, replace.
Piston Seal
Excessive or uneven wear of pad lining may indicate unsmooth re-
turn of the piston. In such a case, replace rubber seal.
ASSEMBLY
Reassemble front brake in reverse order of disassembly, noting the
following points.
CAUTION:
D Wash each part cleanly before installation in the same
fluid as the one used in master cylinder reservoir.
D Never use other fluid or thinner.
D Before installing piston and piston seal to cylinder, apply
fluid to them.
D After reassembling brake lines, bleed air from them.