Suzuki WagonR+ RB310 Service Manual page 2309

5C-6 PARKING AND REAR BRAKE
FORWARD
INSTALLATION
Install parts in reverse order of REMOVAL procedure, noting the fol-
lowing.
1) Distinguish right side parking brake cable from left side one with
its clamp width.
Parking brake cable with narrow clamp should be installed to
right side of vehicle.
2) Apply water tight sealant where plate and cable contact, and run
parking brake cable (1) through brake back plate (2) and secure
it with clip (3).
"A": Sealant 366E, 99000-31090
3) Install brake cable spring (1) and nipple end (2) to parking brake
shoe lever (3) securely as shown in figure.
4) For brake shoe installation, refer to steps 1) to 3) of BRAKE
SHOE INSTALLATION of this section.
5) For brake drum installation, refer to steps 3) to 8) of BRAKE
DRUM INSTALLATION of this section.
6) For proper routing and secure clamping of parking brake cable.
7) Install cable to equalizer.
8) Upon completion of installation, adjust cable. (Refer to PARK-
ING BRAKE INSPECTION AND ADJUSTMENT in SECTION
5.) Then check brake drum for dragging and brake system for
proper performance. After removing vehicle from hoist, brake
test should be performed.