Suzuki WagonR+ RB310 Service Manual page 2249

4-8 FRONT DRIVE SHAFT
INSPECTION
D Check shaft and joint for damage, wear or bend.
Replace them as necessary.
D Check retaining ring and snap ring for breakage or deformation.
Replace as necessary.
ASSEMBLY
For Tripod joint type drive shaft (right side)
1) Wash disassembled parts (except boots and needle bearing of
spider). After washing, dry parts completely by blowing air.
2) Clean boots with cloth. DO NOT wash boot in degreaser, such
as gasoline or kerosene, etc. Washing in degreaser causes de-
terioration of boot.
3) Install new wheel side boot on shaft temporarily.
4) Apply grease to wheel side joint. Use grease in tube included in
wheel side boot set.
"A": HTBJ (High Temperature Birfield Joint) grease/
Grease capacity: About 60 – 80 g (2.1 – 2.8 oz)
5) Fit wheel side boot onto grooves of housing and shaft.
6) Place new wheel side big band onto boot putting band outer end
(1) against forward rotation (2) as shown in figure.
2
7) Fasten boot big band (1) by drawing hooks (2) with plier (3) and
engage hooks (4) in slot and window (5).
Color: Black