Suzuki WagonR+ RB310 Service Manual page 2107

1B-28 AIR CONDITIONING (OPTIONAL)
1. Armature plate
3. Washer
INSTALLATION
1) Install clutch coil (2).
Protrusion on under side of clutch coil must match hole in com-
pressor (3) to prevent movement and correctly locate lead wire.
2) Using special tool (C), install circlip (1) as shown.
Special Tool
(C): 09900-06107
3) Install clutch pulley (1).
(I) Set clutch pulley (1) squarely over clutch pulley installation
boss.
(II) Place special tool (D) onto clutch coil bearing.
Ensure that edge rests only on inner race of bearing.
(III) Install circlip.
Special Tool
(D): 09991-06010
CAUTION:
Be careful not to scratch bearing seal.
4) Adjust clearance, between clutch plate (1) and clutch pulley (2)
by putting shim on compressor shaft.
Standard clearance "a": 0.3 – 0.6 mm (0.012 – 0.024 in.)
5) Tighten new clutch plate bolt (2) as specified below.
Tightening Torque
.
(a): 14 N m (1.4 kg-m, 10.5 lb-ft)
Special Tool
(A): 09991-06020