6A1-24 ENGINE MECHANICAL
OIL PAN AND OIL PUMP STRAINER
REMOVAL
1) Raise vehicle.
2) Drain engine oil by removing drain plug (1).
3) Remove right side of engine under cover.
4) Disconnect oxygen sensor No.2 connector and then remove ex-
haust No.1 pipe with oxygen sensor No.2.
5) Remove clutch housing (torque converter housing for A/T) low-
er plate.
6) Remove CKP sensor (1).
7) Remove oil pan (2) and then oil pump strainer (1).
1. Oil pan:
Apply sealant 99000-31150
to oil pan mating surface
2. Oil pump strainer
3. Seal
4. Drain plug gasket
5. Drain plug
6. CKP sensor
7. Oil pan bolts
8. Oil pan nuts
9. CKP sensor bolt
10. Oil pump strainer bolt
11. Oil pump strainer bracket bolt