Suzuki WagonR+ RB310 Service Manual page 3074

1. Trim cover must face up
2. 185 cm (6 feet) of clearance
3. Mounting attachment
4. M8 bolt and nut
5. Deploying direction
1. Seat belt pretensioner (retractor assembly)
2. Webbing
3. 185 cm (6 feet) of clearance
ii) Place special tool (passenger air bag (inflator) module de-
ployment fixture) on the ground in the space cleared in step
i), if it has not already been placed there.
Special Tool
(B): 09932-75041 or 09932-75040 and 09932-75050
iii) Fill plastic reservoir in fixture (special tool) with water or sand.
This is necessary to provide sufficient stabilization of the fix-
ture during deployment.
iv) Attach the passenger air bag (inflator) module in the fixture
(special tool) using mounting attachment, hold-down bolts
and nuts and M8 bolts and nuts.
NOTE:
Make sure that deploying direction faces as shown in fig-
ure against mounting attachment.
CAUTION:
Be sure to use the following bolt and nut for fixing pas-
senger air bag (inflator) module to mounting attach-
ment. Size: M8, Strength: 7T
Securely hand-tighten all fastener prior to deployment.
[In case of seat belt pretensioner]
i) Pull out the webbing fully as shown in the figure and cut it at
the root of the pretensioner (retractor assembly) as shown in
the figure.
WARNING:
As the drum of the retractor assembly turns very
quickly as soon as the webbing is cut, fix the retractor
assembly with a vise on the workbench and keep your
hands and fingers away from it when cutting the web-
bing.
ii) Clear a space on the ground about 185 cm (6 feet) in diame-
ter where the seat belt pretensioner is to be activated. A
paved, outdoor location where there is no activity is pre-
ferred. If an outdoor location is not available, a space on the
shop floor where there is no activity and sufficient ventilation
is recommended.
Ensure no loose or flammable objects are within the activa-
tion area.
iii) Place the seat belt pretensioner as shown in the figure on the
ground in the space just cleared.
AIR BAG SYSTEM 10B-57