10) Install thermostat case, intake manifold and exhaust manifold.
INSTALLATION
1) Remove old gasket and oil on mating surfaces and install new
A: Crankshaft pulley side
B: Flywheel side
2) Check to make sure that oil jet (venturi plug) is installed and if
3) Apply engine oil to cylinder head bolts and tighten them gradual-
A: Camshaft pulley side
B: CMP sensor case side
9) Install rocker arms, springs, rocker arm shaft as previously out-
lined.
head gasket (1) as shown in figure, that is, "TOP" mark provided
on gasket comes to crankshaft pulley side, facing up (toward cyl-
inder head side).
it is, that it is not clogged.
When installing it, be sure to tighten to specified torque.
Tightening Torque
.
(a): 3.5 N
m (0.35 kg-m, 2.5 lb-ft)
ly as follows.
a) Tighten all bolts to 35 N
numerical order in figure.
b) In the same manner as in a), tighten them to 55 N
(5.5 kg-m, 40.0 lb-ft).
c) Loosen all bolts until tightening torque is reduced to 0 (zero)
in reverse order of tightening.
d) In the same manner as in a), tighten them to 35 N
(3.5 kg-m, 25.0 lb-ft).
e) In the same manner as in a) again, tighten them to specified
torque.
Tightening Torque
.
(a): 68 N
m (6.8 kg-m, 49.5 lb-ft)
ENGINE MECHANICAL 6A1-51
.
m (3.5 kg-m, 25.0 lb-ft) according to
.
m
.
m