Suzuki WagonR+ RB310 Service Manual page 3072

(B)
ALWAYS CARRY AIR BAG (INFLATOR) MODULE
WITH TRIM COVER (AIR BAG OPENING) AWAY
FROM BODY.
ALWAYS PLACE AIR BAG (INFLATOR) MODULE
ON WORKBENCH WITH TRIM COVER (AIR BAG
OPENING) UP, AWAY FROM LOOSE OBJECTS.
1. Slit on workbench
2. Workbench vise
3. Lower mounting bracket
1) Turn ignition switch to "LOCK", remove key and put on safety
glasses.
2) Check that there is no open, short or damage in special tools
(deployment harness and adaptor cable). If any faulty is found,
do not use it and be sure to use new deployment harness and/or
adaptor cable.
Special Tool
(A): 09932-75030
(B): 09932-78320
3) Short the two deployment harness leads (1) together by fully
seating one banana plug into the other.
WARNING:
Deployment harness shall remain shorted and not be
connected to a power source until the air bag is to be
deployed and seat belt pretensioner is to be activated.
4) Remove air bag (inflator) module(s) and seat belt pretension-
er(s) from vehicle, referring to SECTION 3C, 10A or this section.
WARNING:
D Always carry live air bag (inflator) module with trim cov-
er away from you.
D When storing a live air bag (inflator) module or when
leaving a live air bag (inflator) module unattended on a
bench or other surface, always face the bag and trim
cover up and away from the surface. As the live passen-
ger air bag (inflator) module must be placed with its bag
(trim cover) facing up, place it on the workbench with
a slit or use the workbench vise to hold it securely at its
lower mounting bracket.
This is necessary so that a free space is provided to al-
low the air bag to expand in the unlikely event of acci-
dental deployment.
Failure to follow procedures may result in personal inju-
ry.
AIR BAG SYSTEM 10B-55