Suzuki WagonR+ RB310 Service Manual page 2096

INSTALLATION
Reverse removal sequence to install condenser, noting the follow-
ing point.
D If replace condenser, pour 15 cc of refrigerating oil to compressor
suction-side.
D Evacuate and charge system according to previously described
procedure.
INSPECTION
Check the following.
D Condenser fins for leakage, blockage and damage
D Condenser fittings for leakage
Clogged condenser fins should be washed with water, and should
be dried with compressed air.
NOTE:
Be careful not to damage condenser fins. If condenser fin is
bent, straighten it by using a screwdriver or pair of pliers. If any
leakage is found from fitting or tube, repair or replace con-
denser.
RECEIVER/DRYER
REMOVAL
1) Recover refrigerant from refrigeration system by using recovery
and recycling equipment.
2) Remove A/C condenser assembly. Refer to A/C condenser as-
sembly in this section.
3) Loosen receiver/dryer attachment bolts (1), (2).
4) Remove receiver/dryer (3).
INSTALLATION
Reverse removal sequence to install receiver/dryer noting the fol-
lowing points.
D If receiver/dryer (3) is replaced, pour 20 cc of refrigerating oil to
compressor suction-side.
D Evacuate and charge system according to previously described
procedure.
AIR CONDITIONING (OPTIONAL) 1B-17