Suzuki WagonR+ RB310 Service Manual page 2700

REMOVAL
1) Remove console box.
2) Disconnect gear shift and select control cables (1) from gear
shift control lever assembly (2).
a) Disconnect cable end from pivot while pushing cable end
bush (4).
b) Detach cable from bracket (5) while pulling pin (6).
3) Remove gear shift lever assembly mounting control cable guide
nuts (3) and gear shift lever assembly from body.
4) Disconnect shift and select cables from transmission in the
same manner as step 2).
5) Remove cable grommet and cable clamp, and then remove shift
and select cables from body.
INSTALLATION
Reverse removal procedure for installation and note as follows.
D Tighten gear shift control lever assembly mounting nuts to speci-
fied torque.
Tightening Torque
.
13 N m (1.3 kg-m, 9.5 lb-ft)
D Adjustment of shift cable.
With shift control lever in NEUTRAL position, adjust shift cable
adjusting nut (3) so that distance "a" between edge of instrument
panel (1) and center of shift knob (2) measured as shown.
NOTE:
D After shift cable adjustment, tighten lock nut (4) to speci-
fied torque.
Tightening Torque
.
(a): 5.5 N m (0.55 kg-m, 4.0 lb-ft)
D Make sure that boots are installed correctly.
Distance "a": 215 mm (8.46 in.)
MANUAL TRANSMISSION 7A-9