AIR CLEANER ASSEMBLY
REMOVAL
1) Disconnect air cleaner outlet No.1 hose (1) from air cleaner as-
sembly (2).
2) Remove suction pipe (3) from air cleaner assembly.
3) Remove air cleaner assembly by removing bolt (4) shown in fig-
ure.
INSTALLATION
Reverse removal procedure for installation, noting the following.
D Install suction pipe grommet (5) in the direction indicated in figure.
D Clamp each hose securely.
A: Air cleaner side
B: Suction pipe side
AIR CLEANER OUTLET HOSE
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect breather hose (1) from air intake joint (2).
3) Disconnect IAT sensor (3) wire at coupler.
4) Remove air cleaner outlet No.1 hose (4) and No.2 hose (5) with
air intake joint.
INSTALLATION
Reverse removal procedure for installation.
ENGINE MECHANICAL 6A1-11