6) Loosen pinion stop ring (1) fixed by snap ring (2).
7) Remove snap ring, and then pull out pinion stop ring and over-
running clutch (3).
8) Remove armature shaft bushes (1) using special tools.
Special Tool
(A): 09921-20200
(B): 09930-30102
INSPECTION
ARMATURE
D Inspect commutator for dirt or burn. Correct with sandpaper or
lathe, if necessary.
#300X400
D Check commutator for uneven wear with armature (1) supported
on V blocks (2). If deflection of dial gauge pointer exceeds limit,
repair or replace.
NOTE:
Below specification presupposes that armature is free from
bend. Bent shaft must be replaced.
Commutator out of round
D Inspect commutator (1) for wear. If diameter is below limit, replace
armature.
Commutator outside reference diameter
Standard: 0.05 mm (0.0019 in.) or less
Limit:
0.4 mm (0.015 in.)
Standard: 32.0 mm (1.26 in.)
Limit:
31.4 mm (1.24 in.)
CRANKING SYSTEM 6G1-7