Suzuki WagonR+ RB310 Service Manual page 2873

7C-12 CLUTCH
1, "A"
INSPECTION
Clutch release bearing
Check clutch release bearing for smooth rotation.
If abnormality is found, replace it.
CAUTION:
Do not wash release bearing. Washing may cause grease
leakage and consequential bearing damage.
Clutch release shaft
Check clutch release shaft and its pin for deflection or damage.
If abnormality is found, replace it.
INSTALLATION
1) Drive in a new No.1 bush (1) by using special tools and then ap-
ply grease to bush inside.
Special Tool
(A): 09930-30102
(B): 09923-46030
"A": Grease A, 99000-25010
2) Install release shaft with return spring applied to it.
3) Apply grease to No.2 bush (1) inside and press-fit it by using the
same special tool as in removal.
"A": Grease A, 99000-25010
Special Tool
(C): 09922-46010
4) Coat grease to shaft seal (2) lip and then install it till it is flush with
case surface. Use special tool for this installation and face seal
lip downward (inside).
"A": Grease A, 99000-25010
Special Tool
(D): 09925-98221
5) Caulk seal at A by using caulking tool and hammer.