9) Install camshaft timing belt pulley (1) to camshaft while fitting
pin (2) on camshaft into slot at "E" mark.
10) Using special tool, tighten pulley bolt to specified torque.
Tightening Torque
(a): 60 N
Special Tool
(A): 09917-68220
11) After place cylinder head cover on proper position, install belt
tensioner, timing belt, outside cover, crankshaft pulley, water
pump belt and engine right mounting bracket and stiffener as
previously outlined.
12) Remove cylinder head cover.
13) After applying sealant to part "A" as shown in figure at the left,
install CMP sensor case to cylinder head and tighten its fixing
bolts to specified torque.
"A" Sealant: 99000-31110
Tightening Torque
(a): 11 N
Connect CMP sensor connector.
1. O-ring
14) Adjust valve clearance as previously outlined.
15) Install cylinder head cover.
16) After install battery tray and battery, connect positive and nega-
tive cables at battery.
17) Confirm that ignition timing is within specification referring to
"IGNITION SYSTEM" section.
.
m (6.0 kg-m, 43.5 lb-ft)
.
m (1.1 kg-m, 8.0 lb-ft)
ENGINE MECHANICAL 6A1-39