Suzuki WagonR+ RB310 Service Manual page 2211

3D-18 FRONT SUSPENSION
INSTALLATION
1) Place suspension control arm onto flat surface side of special
tool and install new bushing with special tool and oil hydraulic
Press
press as shown.
Special Tool
(A): 09943-77910
NOTE:
D Before installing bushing, apply soap water on its circum-
ference to facilitate installation.
D When installed, bush should be equal on the right and left
of arm as shown.
2) Install suspension control arm to vehicle body and tighten sus-
pension control arm bolt (1) temporarily.
3) Install ball stud (2) to knuckle (1). Align ball stud groove with
knuckle bolt hole as shown.
Then install ball stud bolt from the direction as shown. Tighten
ball stud bolt to specified torque.
Tightening Torque
(a): 60 N
4) Install wheel and tighten wheel nuts to specified torque.
Tightening Torque
(a): 85 N
.
m (6.0 kg-m, 43.5 lb-ft)
.
m (8.5 kg-m, 61.5 lb-ft)