Suzuki WagonR+ RB310 Service Manual page 2892

HOT
LH. HEADLIGHT
SPOT
LH steering vehicle shown
X-X:Horizontal center line of headlight bulb
A-A:Vertical center line of left headlight bulb
B-B:Vertical center line of right headlight bulb
2. For right / left adjustment
3. For up / down adjustment
HEADLIGHT AIMING WITH SCREEN
NOTE:
D Unless otherwise obligated by local regulations, adjust
headlight aiming according to following procedure.
D After replacing headlight, be sure to perform its aiming.
D When inspecting and adjusting headlight with leveling sys-
tem, make sure to set the leveling switch to "0" position with
IG switch ON.
1. Screen
Before adjustment, make sure the following.
a) Place vehicle on a flat surface in front of blank wall as below
ahead of headlight surface.
Clearance "a": 10 m (32.8 ft)
b) Adjust air pressure of all tires to a specified value respectively.
c) Bounce vehicle body up and down by hand to stabilize suspen-
sion.
RH. HEADLIGHT
d) Carry out one driver aboard.
Driver's weight: 75 kg (165 lb)
Adjustment
1) Check to see if hot spot (high intensity zone) of each main (low)
beam axis falls as illustrated.
Clearance "H": Approx. 130 mm (5.15 in.)
2) If headlight aiming is not set properly, align it to specification by
adjusting aiming screw and aiming gear.
LIGHTING SYSTEM 8B-11