Suzuki WagonR+ RB310 Service Manual page 2288

BRAKES PIPE / HOSE / MASTER CYLINDER 5A-15
INSTALLATION
NOTE:
New LSPV assembly is supplied with held in specified spring
length with adjusting block (1).
Do not remove adjusting block until spring (2) installation
position is adjusted.
1) Install LSPV assembly with bracket to vehicle body.
2) Torque each bolt and nut to specification as indicated respec-
tively in figure.
Special Tool
(A): 09950-78230 (10 x 11 mm)
Tightening Torque
.
(a): 26 N m (2.6 kg-m, 19.0 lb-ft)
.
(b): 16 N m (1.6 kg-m, 11.5 lb-ft) (brake flare nut)
.
(c): 26 N m (2.6 kg-m, 19.0 lb-ft)
3) Fill reservoir with specified fluid and bleed air from brake system.
4) Check or adjust spring installation position.
For used LSPV assembly, check that it is installed properly refer-
ring to the following INSPECTION & ADJUSTMENT.
For new LSPV assembly, adjust spring installation position as
follows.
a) Confirm the following before adjustment.
D Fuel level meter indicates around "E" (Empty). (Fuel tank
holds about 5 liters.)
D Vehicle is equipped with spare tire, tools, jack and jack handle.
D Vehicle is free from any other load.
D Vehicle is placed on level floor.
b) Tighten spring bracket bolt to specified torque.
Tightening Torque
.
(a): 5 N m (0.5 kg-m, 4.0 lb-ft)
c) Remove adjusting block (1) from spring (2).
d) Confirm fluid pressure refferring to Fluid Pressure Test in
SECTION 5.