Suzuki WagonR+ RB310 Service Manual page 2105

1B-26 AIR CONDITIONING (OPTIONAL)
MAGNET CLUTCH
: Tightening Torque
INSPECTION
D Check clutch plate and clutch pulley for wear and oil soaked
conditions respectively.
D Check clutch pulley bearing for noise, wear and grease leakage.
D Measure clutch coil for resistance at 20_C.
Standard Resistance: 3.4 – 4.1 Ω
If the measured resistance does not remain within above toler-
ance, replace magnet clutch assembly.
D Use an ohmmeter to check thermal switch for continuity.
If it is no continuity, replace it.
a. Front head bolt
b. Front head bolt
: Tighten bolt (a) first, and
next (b).
c. Armature plate bolt
1. Thermal switch
7
2. Compressor body
3. O-ring
4. Lip type seal
5. Front head
6. Clutch coil
7. Clutch pulley
8. Circlip
9. Circlip
10. Clutch plate