6G-6 CRANKING SYSTEM
2
1
4) Disconnect magnetic switch lead wire and battery cable from
starting motor (1).
5) Remove two starting motor mount bolts (2).
6) Remove starting motor.
7) To install, reverse the above procedure.
DISASSEMBLY
NOTE:
D Before disassembling starting motor, be sure to put match
marks at two locations (A & B) as shown so that any possible
mistake can be avoided.
D Do not clamp yoke in a vise or strike it with a hammer during
repair operations.
1) Remove nut (1) securing the end of field coil lead to terminal on
the head of magnetic switch.
2) Remove magnetic switch (2).
NOTE:
Don't disassemble magnetic switch (1). If defective, replace as
a complete assembly.
3) Remove bolts (1), then separate reduction gear assembly (2)
and ball (3) from starting motor assembly (4).