Suzuki WagonR+ RB310 Service Manual page 3046

Table of Contents

Advertisement

DTC 24: DRIVER AIR BAG INITIATOR CIRCUIT SHORT TO GROUND
STEP
1
Was item "AIR BAG SYSTEM CHECK
FLOW TABLE" described in this section
performed?
2
1) With ignition switch OFF, disconnect
contact coil connector located near the
base of the steering column.
2) Check proper connection to contact coil
at terminals in Q01 connector.
3) If OK then connect Special Tools to "G"
terminal and "G/R" terminal of Q01
connector. (See figure below.)
With ignition switch ON, is DTC 24 current?
3
1) With ignition switch OFF, disconnect
Special Tools and SDM connector.
2) Check continuity between terminals
Q06-26 and Q06-31. (See figure below.)
Is there continuity?
4
1) With ignition switch OFF, disconnect
Special Tools then reconnect contact coil
connector located near the base of the
steering column.
2) Remove driver air bag (inflator) module
from steering wheel (Refer to SECTION
3C).
3) Check proper connection to driver air
bag (inflator) module at terminals.
4) If OK then connect Special Tools to driver
air bag (inflator) module connector. (See
figure below.)
With ignition switch ON, is DTC 24 current?
Fig. for STEP 2
1. G / R wire terminal
2. G wire terminal
Special Tool
(A): 09932-76010
(B): 09932-75010
(C): 09932-78310
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to "Diagnostic Trouble Code (DTC) Clearance"), if any.
3) Repeat "Air Bag Diagnostic System Check" in this section to confirm that the trouble has been cor-
rected.
ACTION
Fig. for STEP 3
YES
Go to step 2.
Go to step 3.
Repair short from "G" or
"G/R" wire circuit to
ground.
1) Ignition switch OFF.
2) Replace contact coil
assembly (Refer to
SECTION 3C).
Fig. for STEP 4
AIR BAG SYSTEM 10B-29
NO
Perform "AIR BAG
SYSTEM CHECK FLOW
TABLE" in this section.
Go to step 4.
Substitute a known-
good SDM and recheck.
1) Ignition switch OFF.
2) Replace driver air bag
(inflator) module (Refer
to SECTION 3C).

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Wagonr+ rb4130Wagonr+ rb413

Table of Contents