Suzuki WagonR+ RB310 Service Manual page 2688

ASSEMBLY
Reverse disassembly procedure for installation, noting the follow-
ing instruction.
D Be sure to install brushes (1) in the proper direction as shown and
solder brush wires (2) and stator leads (3).
D Tighten generator pulley nut (1) to specified torque.
Tightening Torque
.
(a): 118 N m (11.8 kg-m, 85.5 lb-ft)
NOTE:
D When using vise (2), put clean cloth (3) between rotor (4)
and vise so as not to cause damage to rotor.
D Be sure to hold the location A. Do not hold the location B
as it does not have enough structural strength.
D Push brushes into brush holder, then support brushes by insert-
ing appropriate wire (1) before install IC regulator assembly (2)
to rear housing (3).
NOTE:
D After installing rotor, remove wire.
D Check to make sure that match marks on front and rear
housing are aligned.
D Do not apply grease to rear (rotor) bearing. Remove oil
completely if found in bearing box of rear housing.
D After assembling generator, make sure that rotor turns smoothly.
CHARGING SYSTEM 6H-19