Suzuki WagonR+ RB310 Service Manual page 3038

DTC 15 – PASSENGER AIR BAG INITIATOR CIRCUIT RESISTANCE HIGH
DTC 16 – PASSENGER AIR BAG INITIATOR CIRCUIT RESISTANCE LOW
DTC 18 – PASSENGER AIR BAG INITIATOR CIRCUIT SHORT TO GROUND
DTC 19 – PASSENGER AIR BAG INITIATOR CIRCUIT SHORT TO POWER CIRCUIT
1. From main fuse
2. Ignition switch
3. "AIR BAG" fuse in circuit fuse box
4. SDM
5. Passenger air bag (inflator) module
6. Ground for air bag system
CAUTION:
D When measurement of resistance or voltage is required in this table, use a special digital multimeter
(refer to SPECIAL TOOLS in this section) along with a correct terminal adaptor from special tool (Con-
nector test adapter kit).
D When a check for proper connection is required, refer to "Intermittent and Poor Connections" in this
section.
D If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC WILL SET WHEN:
DTC 15: The combined resistance of the passenger air bag (inflator) module, harness wiring and connector termi-
nal contact is above a specified value for specified time.
DTC 16: The combined resistance of the passenger air bag (inflator) module, harness wiring and connector termi-
nal contact is below a specified value for specified time.
DTC 18: The voltage measured at passenger air bag initiator circuit is below a specified value for specified time.
DTC 19: The voltage measured at passenger air bag initiator circuit is above a specified value for specified time.
Q06-31
AIR BAG SYSTEM 10B-21
: Shorting bar
: Air bag harness