Suzuki WagonR+ RB310 Service Manual page 2340

Condition between diagnosis switch terminal
and body ground
About 10 seconds
Open
Short
DIAGNOSTIC TROUBLE CODE (DTC) CHECK
(USING SUZUKI SCAN TOOL)
1) After setting cartridge for ABS to SUZUKI scan tool, connect SU-
ZUKI scan tool to data link connector.
Special Tool
(A): 09931-76011 (SUZUKI scan tool)
(B): Mass storage cartridge
(C): 09931-76030 (16/14 pin DLC cable)
2) Turn ignition switch ON.
3) Read DTC according to instructions displayed on SUZUKI scan
tool and print it or write it down. Refer to SUZUKI scan tool opera-
tor's manual for further details.
4) After completing the check, turn ignition switch off and discon-
nect SUZUKI scan tool from DLC.
DIAGNOSTIC TROUBLE CODE (DTC)
CLEARANCE
WARNING:
When performing a driving test, select a safe place where
there is neither any traffic nor any traffic accident possibil-
ity and be very careful during testing to avoid occurrence of
an accident.
After repair or replace malfunction part(s), clear all DTCs by per-
forming the following procedure.
1) Turn ignition switch OFF.
2) Using service wire (1), connect diagnosis switch terminal (2) of
diagnosis monitor coupler (3) to ground terminal (4).
3) With connection described in above step 2) maintained, turn
ignition switch ON.
4) Repeat disconnecting and reconnecting of service wire between
diagnosis and ground terminals 5 times or more at about 1sec.
interval within 10 seconds.
5) Turn ignition switch OFF and disconnect service wire from moni-
tor coupler.
6) Perform "DRIVING TEST" (step 2 of "ABS DIAGNOSTIC FLOW
TABLE" in this section) and DTC CHECK and confirm that nor-
mal DTC (DTC 12) is displayed; not malfunction DTC.
NOTE:
It is also possible to clear DTC by using SUZUKI scan tool.
Refer to Cartridge Manual for procedure to clear DTC.
ANTILOCK BRAKE SYSTEM (ABS) 5E1-19