Suzuki WagonR+ RB310 Service Manual page 2128

: Tightening Torque
: Do not reuse
LUBRICATION
When inner parts of the steering gear case were dis-
assembled, they should be washed clean before
reassembly. It is recommended to use the grease as
given at the right where grease application is indi-
cated in the text.
ON-VEHICLE SERVICE
1. Steering rack:
Apply grease 99000-25050 to
teeth surface of rack.
2. Steering tie rod
3. Tie rod end
4. Boot
5. Steering pinion:
Apply grease 99000-25050 to
pinion shaft.
* SUZUKI SUPER GREASE (E) 99000-
MANUAL RACK AND PINION 3B-5
6. Steering gear case oil seal:
Apply grease 99000-25050 to oil seal lip.
7. Pinion bearing plug:
Apply grease 99000-25050 to inside of
pinion bearing plug.
Apply thread lock 1342 99000-32050 to
plug thread.
8. O-ring:
Apply grease 99000-25050 to O-ring.
9. Steering pinion needle bearing:
Apply grease 99000-25050 to rollers
of bearing.
10. Lock nut
11. Rack damper screw:
Tighten rack damper screw so that rotation
torque becomes as specified.
Apply sealant 99000-31150 to all around
thread part of rack damper screw.
12. Rack plunger spring
13. Steering rack plunger:
Apply grease 99000-25050 to sliding
part of plunger.
14. Steering rack housing and gear case:
Apply sealant 99000-31120 between
boot and grooves of gear case.
15. Steering rack side mount
16. Steering pinion side mount
17. Tie rod end lock nut
18. Rack boot clip
19. Band
20. Steering shaft join
25050, or Lithium grease (applicable for
–40_C X 130_C or –40_F X 266_F)