Power steering
Manual steering
1, (a)
2, (a)
9) Remove steering gear case mount bolts (1), nuts (2) and gear
case brackets, then remove gear case (3).
INSTALLATION
1) Apply grease to inside of pinion packing and install pinion pack-
ing onto pinion. Mount steering gear case (1) to body and tighten
gear case mount bolts (2) and nuts (3) to specified torque.
Tightening Torque
.
(a): 25 N
m (2.5 kg-m, 18.0 lb-ft)
2) Install engine rear mounting bolt (1).
Tighten bolts to specified torque.
Tightening Torque
.
(a): 55 N
m (5.5 kg-m, 40.0 lb-ft)
3) Remove transmission jack.
4) Install tie rod ends to knuckles (right & left). Tighten each new
tie rod end nut (1) to specified torque.
Tightening Torque
.
(a): 43 N
m (4.3 kg-m, 31.5 lb-ft)
5) Be sure that steering wheel and brake discs (right & left) are all
straight-ahead position and then insert steering lower joint into
steering pinion shaft.
6) Tighten steering shaft joint bolts (1) and (2) to specified torque
(Lower side first and then upper side).
Tightening Torque
.
(a): 28 N
m (2.8 kg-m, 20.5 lb-ft)
MANUAL RACK AND PINION 3B-9