Handling Precaution - Suzuki WagonR+ RB310 Service Manual

3C-4 STEERING WHEEL AND COLUMN
ii) Connect connector.
ii) Lock connector with lock lever.
ENABLING AIR BAG SYSTEM
1) Turn ignition switch to "LOCK" and remove key.
2) Connect connector to contact coil assembly, and install steering
column upper cover and lower cover.
3) Connect Yellow connector of passenger air bag (inflator) module
if equipped, and be sure to lock connector with lock lever and
close glove box panel.
4) Install "AIR BAG" fuse to the circuit fuse box.
5) Turn ignition switch to "ON" and verify that "AIR BAG" warning
lamp flushes 6 times and then turns OFF.
If it does not operate as described, perform "Air Bag Diagnostic
System Check" in SECTION 10B.

HANDLING PRECAUTION

LIVE (UNDEPLOYED) DRIVER AIR BAG (INFLATOR)
MODULE
WARNING:
Never attempt to measure the resistance of the air bag (in-
flator) module. It is very dangerous as the electric current
from the tester may deploy the air bag.
Special care is necessary when handling and storing a live (unde-
ployed) air bag (inflator) module. The rapid gas generation pro-
duced during deployment of the air bag could cause the air bag (in-
flator) module, or an object in front of the air bag (inflator) module,
to be thrown through the air in the unlikely event of an accidental
deployment.
D Never attempt disassembly of the air bag (inflator) module.
D If any abnormality is found, be sure to replace it with new one as
an assembly.
D When grease, cleaning agent, oil, water, etc., got on the air bag
(inflator) module, wipe it off immediately with a dry cloth.