Suzuki WagonR+ RB310 Service Manual page 2974

"a": Approx. 5mm
(0.197 in.)
4. Molding
1. Do not apply primer
3. Apply primer
10) Using knife (1), smoothen adhesive (2) remaining on body side
(3) so that it is 1 to 2 mm thick all around.
NOTE:
Before using knife, clean it with alcohol or the like to re-
move oil from it.
11) When reusing windshield, remove the adhesive (1) from it, us-
ing care not to damage primer coated surface (2).
INSTALLATION
1) Using cleaning solvent, clean windshield edge where wind-
shield glass is to be adhered. (Let it dry for more than 10 min-
utes.)
2) Install new glass stoppers (1) (2pcs) to lower side of windshield.
3) To determine installing position of glass (1) to body (2), position
glass against body so that clearance between upper end of
glass (1) and body (2) is about 5 mm (0.197 in.) and clearances
between each side end (right & left) of glass (1) and body (2) are
even. Then mark mating marks (3) on glass (1) and body (2) as
shown. Upper clearance can be adjusted by moving stoppers
position.
4) Clean contact surfaces of old adhesive (4), paint or bare metal
thoroughly.
If surfaces of paint or bare metal come out, apply primer (2) for
body with caution not to apply primer (2) to surface of adhesive
remaining on body.
NOTE:
D Be sure to refer to primer maker's instruction for proper
handling and drying time.
D Do not touch body and old adhesive surfaces where glass
is to be adhered.
BODY SERVICE 9-13