Suzuki WagonR+ RB310 Service Manual page 2798

REMOUNTING
1) Make sure that torque converter is installed correctly to trans-
mission.
Refer to UNIT ASSEMBLY in this section.
2) Attach transmission to engine.
Tightening Torque
(a): 50 N
3) Tighten drive plate-torque converter bolts.
Align drive plate bolt hole and torque converter through starter
motor mounting opening then tighten bolts through torque con-
verter housing lower plate opening.
Lock drive plate (1) by engaging a flat head rod or the like (2) with
drive plate gear.
2
Tightening Torque
(a): 20 N
3. Wrench
4. Engine oil pan
4) Install torque converter housing lower plate (1).
5) Install starting motor.
Tightening Torque for Starter Bolts:
23 N
6) Remount engine with transmission assembly to vehicle. Refer
to Section 6A1 for its procedure.
.
m (5.0 kg-m, 36.0 lb-ft)
WARNING:
Be sure to keep transmission with torque converter hori-
zontal or facing up throughout the work. Should it be
tilted with torque converter down, converter may fall off
and cause personal injury.
.
m (2.0 kg-m, 14.5 lb-ft)
.
m (2.3 kg-m, 16.5 lb-ft)
AUTOMATIC TRANSMISSION (4 A / T) 7B-67