9-40 BODY SERVICE
DISASSEMBLY
1) Remove sunshade. Refer to "SUNSHADE" in this section.
2) Remove sliding roof deflector. Refer to "SLIDING ROOF DE-
FLECTOR" in this section.
3) Remove crank drive. Refer to "CRANK DRIVE" in this section.
4) Pull-out side guide (1) and rear guide (2) with action cable from
guide rail.
5) Detach gutter guide (1), rear guide with actuation cable (2) and
front guide with detent lever (3) from side guide (4).
ASSEMBLY
Reverse disassembly procedure for assembly, observing the fol-
lowing instructions.
D Adjust crank drive position as follows.
1) Install crank handle (3) to crank drive (1) temporary.
2) Push crank (1) onto drive (2) by pushing press bottom (4).
3) Turn crank (1) clockwise to stop position.
4) Turn crank back three whole turns until lock position is reached.
5) Crank must now fit into recess provided.
If did not properly position, readjust crank drive position.
NOTE:
If crank drive is properly operates, crank drive is stopped
at "Open" position after 8 turns from adjusted position and
crank drive attains its end position when the button is
pressed and the crank drive turned another 2 turns.