Suzuki WagonR+ RB310 Service Manual page 2208

FORWARD
2) Install knuckle (2) to ball stud (3) on suspension control arm (4)
and strut bracket (1). Installing direction of each bolt is as shown.
Align knuckle bolt hole with ball stud groove and install ball stud
bolt (5). Tighten each bolt and nuts to specified torque.
Tightening Torque
(a): 115 N
(b): 60 N
FORWARD
3) Install wheel speed sensor (if equipped).
4) Connect tie-rod end (1) to knuckle (2) and install new tie-rod end
nut (3).
Tighten tie-rod end nut to specified torque.
Tightening Torque
(c): 43 N
5) Tighten new drive shaft nut temporarily.
6) Install brake disc.
7) Install brake caliper/caliper carrier.
8) Tighten caliper carrier bolts to specified torque.
Tightening Torque
(b): 95 N
.
m (11.5 kg-m, 83.5 lb-ft)
.
m (6.0 kg-m, 43.5 lb-ft)
.
m (4.3 kg-m, 31.5 lb-ft)
.
m (9.5 kg-m, 69.0 lb-ft)
FRONT SUSPENSION 3D-15