Suzuki WagonR+ RB310 Service Manual page 2922

The illustration shows LH steering vehicle.
And RH steering vehicle is symmetrical.
WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-11
WASHER LINKED CIRCUIT
INSPECTION
1) Check that wiper motor operates with the wiper switch at low
position, and return to original position with the wiper switch
turned OFF.
2) Disconnect negative cable at battery.
3) Disable air bag system. Refer to DISABLING AIR BAG SYSTEM
in Section 10B.
4) Pull out intermittent timer (1) and disconnect coupler, and con-
nect negative cable at battery.
5) Check that the voltage and resistance between following termi-
nals are specification.
Terminals
When ignition switch is
in OFF.
G51-2 and
ground
When ignition switch is
in ON.
G51-6 and
ground
G51-8 and
ground
When ignition switch is in
ON and washer switch is
in OFF.
G51-4 and
ground
When ignition switch is in
ON and washer switch is
in ON.
If check result is not satisfactory, repair.
REFERENCE:
When front washer switch is in ON position for one second
or more and then turned OFF, the wiper motor operates at
low speed for approximately 5 seconds after front washer
switch is turned OFF.
6) After intermittent lead wire coupler is connected and intermittent
timer is installed, enable air bag system. Refer to ENABLING
AIR BAG SYSTEM in Section 10B.
Condition Specification
10 – 15 V
——— Continuity
——— Continuity
10 – 15 V
0 V
0 V