6A1-18 ENGINE MECHANICAL
TIMING BELT AND BELT TENSIONER
14
: Tightening Torque
REMOVAL
1) Disconnect negative cable at battery.
2) Remove right side of engine under cover (1).
3) Disconnect A/C suction and discharge hoses from A/C com-
pressor.
4) Remove A/C compressor and its bracket (if equipped), refer to
Section 1B.
5) Remove suction pipe and air cleaner assembly.
6) Support engine by using support device.
7) Remove engine right mounting bracket (1), stiffener (2) and en-
gine right mounting swing bracket (3).
1. Timing belt
2. Tensioner
3. Tensioner plate
4. Tensioner spring
5. Camshaft timing pulley
6. Tensioner bolt
7. Pulley bolt
8. Seal
9. Inside cover seals
10. Inside cover
11. Outside cover seal
12. Outside cover
13. Tensioner stud
14. Outside cover bolts
15. Outside cover nut