Delta ASDA-B2-F Series User Manual page 216

ASDA-B2-F
AL289 Feedback position counter overflows
Causes
Feedback position counter
overflows.
AL301 DMCNET fails to synchronize
Causes
DMCNET fails to
synchronize.
The synchronized signal of DMCNET is
AL302
sent too fast
Causes
The synchronized signal of
DMCNET is sent too fast.
The synchronized signal of DMCNET is
AL303
sent too slow
Causes
The synchronized signal of
DMCNET is sent too slow.
AL304 DMCNET IP command fails
Causes
DMCNET IP command fails.
AL555 System failure
Causes
DSP processing error
September, 2015
Checking Method
N/A
Checking Method
1. Check if the communication quality of
the cable is normal.
2. Check if the controller sends SYNC
signal successfully.
3. Check if the setting of P3-09 is
reasonable. (It is better to use the
default value)
Checking Method
1. Check if the setting of P3-09 is
reasonable. (It is better to use the
default value)
2. Check if the order of the controller is
correct.
Checking Method
1. Check if the communication quality of
the cable is normal.
2. Check if the setting of P3-09 is
reasonable. (It is better to use the
default value)
3. Check if the order of the controller is
correct.
Checking Method
If the calculating time of IP mode is too
long, please disable USB monitoring
function.
Checking Method
N/A
N/A
Corrective Actions
If this alarm occurs, please
directly send the servo drive back
to Delta without making any
modification.
Issue alarm reset to clear this alarm
Corrective Actions
Issue alarm reset
Issue alarm reset to clear this alarm
Corrective Actions
Issue alarm reset.
Issue alarm reset to clear this alarm
Corrective Actions
Issue alarm reset.
Issue alarm reset to clear this alarm
Corrective Actions
Issue alarm reset.
N/A
Corrective Actions
If this alarm occurs, please
directly send the servo drive back
to Delta without making any
modification.
Troubleshooting
9
9-15