Delta ASDA-B2-F Series User Manual page 156

ASDA-B2-F
Settings:
When the environmental noise is big, increasing the setting value can enhance the control stability.
However, if the value is set to be too big, the response time will be influenced.
P2-10
Operational
Panel / Software
Interface:
Default: 101
Unit: -
Format: HEX
Settings:

Input function selection: Please refer to Table 7.1

Input contact: a or b contact
0: Set the input contact as normally closed (b contact)
1: Set the input contact as normally opened (a contact)
(P2-10 ~ P2-17) The setting value of function programmed
When parameters are modified, please re-start the servo drive to ensure it can work normally.
Note: Parameter P3-06 is used to set how digital inputs (DI) accept commands, through external terminal or
communication determined by P4-07.
P2-11
Operaional
Panel / Software
Interface:
Default: 104
Unit: -
Format: HEX
Settings:
Please refer to the description of P2-10.
P2-12
Operational
Panel / Software
Interface:
Default: 022
Unit: -
Format: HEX
Settings:
Please refer to the description of P2-10.
September, 2015
DI1 DI1 Functional Planning
Communication
Input function selection
Input contact
Not in use
DI2 DI2 Functional Planning
Communication
DI3 DI3 Functional Planning
Communication
Address: 0214H
Related
Table 7.1
Section:
Control
ALL
Mode
0 ~ 0x015F (The last two codes are
Range:
DI code)
Data Size: 16-bit
Address: 0216H
Related
Table 7.1
Section:
Control
ALL
Mode:
0 ~ 0x015F (The last two codes are
Range:
DI code)
Data Size: 16-bit
Address: 0218H
Related
Table 7.1
Section:
Control
ALL
Mode:
0 ~ 0x015F (The last two codes are
Range:
DI code)
Data Size: 16-bit
Parameters
7
0215H
0217H
0219H
7-39