Delta ASDA-B2-F Series User Manual page 131

Parameters
P0-21
Operational
Interface:
Default: 0
7
Format: DEC
Settings:
Please refer to the description of P0-02 for the setting value.
P0-22~P0-24
P0-25
Operational
Interface:
Default: No need to initialize
Format: HEX
Settings:
Users can continuously read and write parameters that are not in the same group. The content of
the parameter that is specified by P0-35 will be shown in P0-25. Please refer to the description of
P0-35 for parameter setting.
P0-26
Operational
Interface:
Default: No need to initialize
Format: HEX
Settings:
The using method is the same as P0-25. The mapping target is set by parameter P0-36.
P0-27
Operational
Interface:
Default: No need to initialize
Format: HEX
Settings:
The using method is the same as P0-25. The mapping target is set by parameter P0-37.
P0-28
Operational
Interface:
Default: No need to initialize
Format: HEX
Settings:
The using method is the same as P0-25. The mapping target is set by parameter P0-38.
7-14
CM5A Status Monitor Register 5 Selection
Panel / Software Communication
Unit: -
Reserved
MAP1 Mapping Parameter# 1
Panel / Software Communication
Unit: -
MAP2 Mapping Parameter# 2
Panel / Software Communication
Unit: -
MAP3 Mapping Parameter# 3
Panel / Software Communication
Unit: -
MAP4 Mapping Parameter# 4
Panel / Software Communication
Unit: -
Address: 002AH
Related
-
Section:
Control
-
Mode:
Range: 0 ~ 127
Data Size: 16-bit
Address: 0032H
Related
4.3.5
Section:
Control
ALL
Mode:
Determined by the corresponding
Range:
parameter of P0-35
Data Size: 32-bit
Address: 0034H
Related
4.3.5
Section:
Control
ALL
Mode:
Determined by the corresponding
Range:
parameter of P0-36
Data Size: 32-bit
Address: 0036H
Related
4.3.5
Section:
Control
ALL
Mode:
Determined by the corresponding
Range:
parameter of P0-37
Data Size: 32-bit
Address: 0038H
Related
4.3.5
Section:
Control
ALL
Mode:
Determined by the corresponding
Range:
parameter of P0-38
Data Size: 32-bit
ASDA-B2-F
002BH
0033H
0035H
0037H
0039H
September, 2015