Delta ASDA-B2-F Series User Manual page 157

Parameters
P2-13
Operational
Interface:
Default: 023
7
Format: HEX
Settings:
Please refer to the description of P2-10.
P2-14
Operational
Interface:
Default: 021
Format: HEX
Settings:
Please refer to the description of P2-10.
P2-15~P2-17
P2-18
Operational
Interface:
Default: 101
Format: HEX
Settings:

Output function selection: Please refer to Table 7.2

Output contact: a or b contact
P2-19
Operational
Interface:
Default: 103
Format: HEX
Settings:
Please refer to the description of P2-18
7-40
DI4 DI4 Functional Planning
Panel / Software Communication
Unit: -
DI5 DI5 Functional Planning
Panel / Software Communication
Unit: -
Reserved
DO1 DO1 Functional Planning
Panel / Software Communication
Unit: -
0: Set the output contact as normally closed (b contact)
1: Set the output contact as normally opened (a contact)
(P2-18 ~ P2-22) The setting value of function programmed
When parameters are modified, please re-start the servo drive to ensure it can work normally.
DO2 DO2 Functional Planning
Panel / Software Communication
Unit: -
Related
Section:
Control
Range:
Data Size: 16-bit
Related
Section:
Control
Range:
Data Size: 16-bit
Related
Section:
Control
Range:
Output function selection
Output contact
Not in use
Related
Section:
Control
Range:
Data Size: 16-bit
Address: 021AH
Table 7.1
ALL
Mode:
0~ 0x15F (The last two codes are
DI code)
Address: 021CH
Table 7.1
ALL
Mode:
0 ~ 0x015F (The last two codes are
DI code)
Address: 0224H
Table 7.2
ALL
Mode:
0 ~ 0x013F (The last two codes are
DO code)
Data 16-bit
Address: 0226H
Table 7.2
ALL
Mode:
0 ~ 0x013F (The last two codes are
DO code)
ASDA-B2-F
021BH
021DH
0225H
0227H
September, 2015