Chrysler 1997 Stratus Convertible RHD Service Manual page 756

9 - 20 2.4L ENGINE
REMOVAL AND INSTALLATION (Continued)
Fig. 17 Engine Support Module
INSTALLATION
(1) Install thru bolt at front mount. Do not tighten
at this time.
(2) Install lower radiator support.
(3) Install attaching bolts from support module to
lower radiator support.
(4) Install upper bolt at rear support strut bracket. SUPPORT TRANSMISSION STRUT
(5) Install thru bolt at rear mount see (Fig. 18) or
(Fig. 19) tighten to 61 N·m (45 ft. lbs.).
(6) Tighten thru bolt at front mount see (Fig. 20)
tighten to 61 N·m (45 ft. lbs.).
Fig. 18 Engine Mounting—Rear 2.4 and2.5L
LEFT SIDE MOUNT
NOTE: If centering or adjusting the engine/trans-
mission assembly is needed refer to Adjustments,
in this section.
The left side engine mount is a Hydro-Mount and
may show surface cracks this will not effect it's
performance and should not be replaced. Only
replace the Hydro-Mount when it's leaking fluid.
110 N·m (80 ft. lbs.) 61 N·m (45 ft. lbs.) REAR TORQUE BRACKET TORQUE CLIP STARTER WIRING ENGINE ENGINE) (2.5L
Fig. 19 Engine Mounting—Rear 2.0L
(1) Support the transmission with a transmission
jack.
(2) Remove the three vertical bolts, from the
mount to the transmission.
(3) Remove the transmission mount fasteners and
remove mount.
(4) Reverse removal procedure for installation.
Refer to (Fig. 21) for bolt tightening specifications.
(5) Engine support assemblies adjustment, Refer
to Engine Support Assembly Adjustment of this sec-
tion.
ENGINE MOUNT—RIGHT/ENGINE SUPPORT
BRACKET
NOTE: The right side engine mount is a Hydro-
Mount and may show surface cracks this will not
effect it's performance and should not be replaced.
Only replace the Hydro-Mount when it's leaking
fluid.
JX