Chrysler 1997 Stratus Convertible RHD Service Manual page 1116

RETAINING BRACKET REAR SEAT BACK FLOOR PAN
REAR SEAT BACK SUPPORT
23 - 46 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 59 Rear Seat Back
(3) Lower rear seat back until center loop begins
to engage.
(4) Lower rear seat back and push rearward on
outboard corners of seat back to engage outboard
hooks to brackets on rear seat back support.
(5) Push downward on rear seat back until all
hooks are fully engaged into retaining brackets.
(6) Install rear inner seat belt assembly.
(7) Install rear seat cushion.
NOTE: Torque specification for rear inner seat belt
assembly is 40 N·m (350 in. lbs.).
QUARTER TRIM PANEL
REMOVAL
(1) Lower convertible top.
(2) Remove rear seat cushion and rear seat back.
(3) Remove door sill trim panel.
(4) Remove push-in fastener holding quarter trim
panel to door sill panel.
(5) Remove speaker grille (Fig. 60).
(6) Remove vertical screws and inboard velcro
screw holding quarter trim panel to inner quarter
panel (Fig. 61).
(7) Remove screws holding quarter trim panel to
inner quarter panel through the speaker opening.
(8) Remove screws holding quarter trim panel to
inner quarter panel at rear of trim panel.
(9) Remove push–in fasteners holding quarter trim
panel to inner quarter panel at front of trim panel.
(10) Pull trim panel from inner quarter panel and
disconnect speaker wiring connector.
(11) Separate quarter trim panel from vehicle.
INSTALLATION
(1) Position quarter trim panel on vehicle.
(2) Connect speaker wiring connector.
INBOARD VELCRO SCREW QUARTER TRIM PANEL PUSH IN FASTENER SPEAKER GRILLE SCREWS
INNER QUARTER PANEL QUARTER TRIM PANEL
Fig. 60 Speaker Grille
Fig. 61 Quarter Trim Panel
(3) Install push–in fasteners holding quarter trim
panel to inner quarter panel at front of trim panel.
(4) Install screws holding quarter trim panel to
inner quarter panel through the speaker opening.
(5) Install vertical screws and inboard velcro screw
holding quarter trim panel to inner quarter panel.
(6) Install screws holding quarter trim panel to
inner quarter panel at rear of trim panel.
(7) Install push-in fastener holding quarter trim
panel to door sill panel.
(8) Install door sill trim panel.
(9) Install speaker grille.
(10) Install rear seat cushion and rear seat back.
JX