Chrysler 1997 Stratus Convertible RHD Service Manual page 401

JX
DESCRIPTION AND OPERATION (Continued)
Fig. 3 Circuit Identification
CONNECTORS
Connectors shown in the diagrams are identified
using the international standard arrows for male and
female terminals (Fig. 4). A connector identifier is
placed next to the arrows to indicate the connector
number (Fig. 4).
For viewing connector pin outs, with two terminals
or greater, refer to section 8W-80. This section iden-
8W - 01 GENERAL INFORMATION
Fig. 4 Connector Identification
tifies in-line connectors by number, and component
connectors by name. If a component has two or more
connectors they will be identified as C1, C2, C3...etc.
This sections also provides terminal numbering, cir-
cuit identification, wire colors, and functions.
All connectors are viewed from the terminal end
unless otherwise specified. To find the connector loca-
tion in the vehicle refer to section 8W-90. This sec-
tion uses the connector identification number from
the wiring diagrams to provide a figure number ref-
erence.
TAKE OUTS
The abbreviation T/O is used in the component
location section to indicate a point in which the wir-
ing harness branches out to a component.
SYMBOLS
Various symbols are used throughout the Wiring
Diagrams. These symbols can be identified by refer-
ring to the symbol identification chart (Fig. 5).
8W - 01 - 3