Chrysler 1997 Stratus Convertible RHD Service Manual page 975

TORQUE CONVERTER OFF LOW/REVERSE CLUTCH UNDERDRIVE CLUTCH OVERDRIVE CLUTCH REVERSE CLUTCH 2/4 CLUTCH
JX
DIAGNOSIS AND TESTING (Continued)
Shift Lever Position
P — PARK
R — REVERSE
N — NEUTRAL
OD — OVERDRIVE
First—
Second
Direct
Overdrive
3 — DRIVE GEAR*
First
Second
Direct
L — LOW*
First
Second
Direct
*Vehicle upshift and downshift speeds are increased when in these selector positions.
Fig. 2 ELEMENTS IN USE AT EACH POSITION OF THE SELECTOR LEVER
Fig. 3 Pressure Taps
(7) This test checks the overdrive clutch hydraulic
circuit as well as the shift schedule.
TEST FOUR-SELECTOR IN CIRCLE DRIVE,
OVERDRIVE GEAR
(1) Attach gauge to the 2/4 clutch tap.
(2) Move selector lever to the (Circle D) position.
(3) Allow vehicle front wheels to turn and increase
throttle opening to achieve an indicated vehicle speed
of 30 mph.
Start Park
Safety Sprag
Underdrive
X X
X
CLUTCHES
Overdrive
X
X
X X
X
X
X
X X
X
X
X X
(4) The 2/4 clutch pressure should read 75 to 95
psi.
(5) This test checks the 2/4 clutch hydraulic cir-
cuit.
TEST FIVE-SELECTOR IN CIRCLE DRIVE,
OVERDRIVE
(1) Attach gauge to the torque converter clutch off
pressure tap.
(2) Move selector lever to the (Circle D) position.
(3) Allow vehicle wheels to turn and increase
throttle opening to achieve an indicated vehicle speed
of 50 mph.
CAUTION: Both wheels must turn at the same
speed.
(4) Torque converter clutch off pressure should be
less than 5 psi.
(5) This test checks the torque converter clutch
hydraulic circuit.
TEST SIX-SELECTOR IN REVERSE
(1) Attach gauge to the reverse and LR clutch tap.
(2) Move selector lever to the reverse position.
(3) Read reverse clutch pressure with output sta-
tionary (foot on brake) and throttle opened to achieve
1500 rpm.
TRANSAXLE
Reverse 2/4
X
X
X
X
21 - 7
Low/
Reverse
X
X
X
X
X
X